• Home
  • -
  • 100G QSFP28 DR1 optical transceiver, SM, single lambda 1310nm, 500m reach, Dual LC [SSF-QSFP-100GDR1]

100G QSFP28 DR1 optical transceiver, SM, single lambda 1310nm, 500m reach, Dual LC [SSF-QSFP-100GDR1]

(0)No Reviews yet
SKU: SSF-QSFP-100GDR1

Details

This product is a transceiver module designed for 500m optical communication applications. The module incorporates one channel optical signal, on 1310nm center wavelength, operating at 50Gbaud data rate. The transmitter path incorporates an EML Driver integrated in the DSP and a cooled EML together. On the receiver path, the input optical signal is coupled to a Pin photodiode detector. A DSP based gearbox is used to convert 4x25Gbps NRZ signals to 1x50Gbaud PAM4 signal. Also, a 4-channel re-timer and FEC block are integrated in this DSP. The electrical interface is compliant with IEEE 802.3cd and QSFP28 MSA in the transmitting and receiving directions, and optical interface is compliant to IEEE 802.3cd and 100G Lambda MSA with Duplex LC connector. The module has a maximum power consumption of 4.0W.

The product is designed with form factor, optical/electrical connection and digital diagnostic interface according to the QSFP28 Multi-Source Agreement (MSA). It has been designed to meet the harshest external operating conditions including temperature, humidity and EMI interference.

This product converts the 4-channel of 100Gbps aggregated NRZ electrical input data into one channel of 50Gbaud PAM4 optical signal (light) on 1310nm center wavelength through a DSP based gearbox, by a driven cooled Electro-absorption Modulated DFB Laser (EML). The light propagates out of the transmitter into an SMF fiber. The reciever module accepts the 50Gbaud PAM4 optical signal input, and convverts it into a 50Gbaud PAM4 electrical signal via a linear amplifier. And then convert the 50Gbaud PAM4 signal into 4 channels of 25Gbps NRZ signals, Figure 1 shows the functional block diagram of this product.

A single +3.3V power supply is required to power up this product. Both power supply pins VccTx and VccRx are internally connected and should be applied concurrently. As per MSA specifications the module offers seven low speed hardware control pins (including the 2-wire serial interface): ModSelL, SCL, SDA, ResetL, LPMode, ModPrsL and IntL.

FEATURES AND BENEFITS
  • QSFP28 MSA compliant
  • Supports 53.125Gbaud
  • 100G Lambda MSA 100G-DR specification complaint
  • Up to 500m transmission on single mode fibe (SMF) with FEC
  • Operating case temperature: 0 to 70°C
  • 4x25G electrical interface (OIF CEI-28G- VSR)
  • Maximum power consumption 4W
  • Accepts LC duplex connectors
  • RoHS compliant

DOWNLOADS

Specification Sheet

Ratings & Reviews

No reviews available

Be the first to Write a Review